Class List

Here are the classes, structs, unions and interfaces with brief descriptions:

AccelStepperPositionSetter	Setter class that outputs its value to set the position of an AccelStepper
AccelStepperSpeedSetter	Setter class that outputs its value to set the speed of an AccelStepper
AnalogSetter	Setter class that sets its value to an analog output pin
DifferentialLRSetter	Setter class cluster that provides the left-right input to a DifferentialSetter
DifferentialSetter	Setter class cluster that controls 2 analog outputs based on 2 analog inputs so that a joystic can be used to control 2 motors like on a tank or bulldozer or concentric rotor helicopter. inputA controls forwars/reverse and inputB controls left/right
DigitalSetter	Setter class that sets its value to an analog output pin
EthernetTransceiver	Defines an Ethernet RCOIP Transceiver
HBridgeSetter	Setter class that outputs its value to a HBridge configured on 2 output Setter
Inverter	Setter object that inverts its value
Limiter	Setter class that limits its output to between specified min and max values
Linear	Setter class that implements linear transform of its input value
MotorControllerSetter	Setter class that outputs its value to a MotorController configured on 1 digital and one analog output pins
RCOIP	This section describes the RCOIP (Remote Control Over IP) protocol
RCOIPv1CmdSetAnalogChannels	SetAnalogChannels command message structure
RCOIPv1ReplyReceiverStatus	ReceiverStatus reply message structure
RCRx	Remote Control Receiver module for RCOIP protocol on Arduino
ServoSetter	Setter class that limits its input to between specified min and max values
Setter	Virtual base class for classes that receive a value, maybe transform it and then do something with it
SetterDebug	Class for testing Setters. Used by the sample TestSuite sketch
Transceiver	Abstract base class for a transceiver device that will send and receive messages on behalf of RCRx class
WiShieldTransceiver	Defines a WiSHield RCOIP Transceiver